What should you know before using a milling machine?
Milling machines can be dangerous if not used properly.
- Read the owner's manual carefully.
- Make sure you understand instructions and are properly trained before operating a milling machine.
Refer to Metalworking Machines - General for basic safety tips.
What are some safe work principles to follow when using a milling machine?
- Wear appropriate safety glasses.
- Ensure that the milling machine has a start/stop button within easy reach of the operator.
- Ensure that the work piece and cutter are mounted securely before taking a cut.
- Check that work is mounted squarely.
- Mount work in a vise that is bolted or held magnetically to the table. Use proper hand tools to make adjustments. Refer to Hand Tools for more information.
- Hold milling cutters with a cloth to avoid being cut when handling them.
- Move table as far as possible from cutter while setting up work to avoid injuring your hands.
- Mill the largest surface first.
- Keep hands, brushes and rags away from the revolving milling cutter.
- Use a vacuum, brush or rake to remove cuttings only after the cutters have stopped moving.
- Change cutting compounds periodically.
- Keep cutters sharpened correctly and in good condition.
- Keep working surface clear of scraps, tools and materials.
- Remove cutting tools from spindle when cleaning the machine.
- Keep floor around the milling machine free of oil and grease.
- Use lifting equipment when appropriate to move heavy work to or from milling machines. Refer to Materials Handling for more information.
- Make sure the power is off before changing cutters.
- Always stay at the machine when it is in operation.
Before starting the machine, what should you check?
Before starting, make sure that:
- all guards are in place;
- work is properly secured in place;
- bolts used to hold down work clear the tooling;
- tooling and supporting pieces are properly tightened in position;
- table stops are secured properly;
- handles on all feed screws are in neutral;
- table is free of stock, tools or other loose material;
- the arbor and arbor support are clear of the work;
- the cutter is rotating in the right direction.
What should you consider when setting the cutting speed?
Ensure that the following factors are considered when setting cutting speed:
- material to be machined;
- type of cutter;
- finish required;
- depth of cut;
- rigidity of machine and work piece.
What are some things you should avoid doing?
- Do not wear gloves, rings, watches or loose clothing. Tie back long hair.
- Do not attempt to mount, measure or adjust work until cutter is completely stopped.
- Do not use an excessively heavy cut or feed as it can cause the cutter to break. The flying pieces could cause serious injury.
- Do not reach over or near a revolving cutter. Keep hands at least 30 cm (12 in.) from a revolving cutter.
- Do not lean or rest hands on a moving table.
- Do not make any adjustments while the machine is running.
- Do not use paper shims to check the distance from the cutter to the stock.
- Do not move the operating levers without knowing what they control and what action is going to take place.
- Do not leave machine unattended while it is running.
Document last updated on August 8, 2011
Copyright ©1997-2013 Canadian Centre for Occupational Health & Safety