What should you do before using sanders?
Sanders can be dangerous if not used properly.
- Read the owner's manual carefully.
- Make sure you understand instructions before attempting to use any tool or machine.
- Learn the applications and limitations before use.
- Refer to Woodworking Machines - General Safety Tips for general safeguards.
What safety procedures should you follow when using sanders?
- Wear goggles when operating sanders.
- Wear hearing protection that is suitable for the level and frequency of the noise you are exposed to in the woodworking area.
- Wear protective footwear when required.
- Use sanders with the local exhaust ventilation (LEV) turned on. The LEV should be designed for the sander and well maintained to work effectively.
- Wear respiratory protection (e.g., dust masks) where required, during sanding operations and clean up.
- Keep hands away from the abrasive surface.
- Hold small or thin pieces of stock in a jig or holding device to prevent injuries to the fingers or hands.
- Inspect abrasive belts before using them. Replace belts worn, frayed, or excessively worn in spots.
- Sand on the downward side of a disc sander so that the wood is driven onto the table by the machine's rotation.
- Enclose all drums, disk or belt sanding machines with an exhaust dust hood that covers all portions of the machine but the portion designed for the work feed.
- Adjust work rests on all manually fed sanders to provide minimum clearance between the belt and the rest. The work rest should be secured properly.
- Install abrasive belts that are the same width as the pulley drum.
- Adjust abrasive belt tension to keep the belt running the same speed as pulley-drum when the wood is in contact with the belt.
- Guard feed rollers to allow boards to pass, but keep operators' fingers and arms out.
- Install guards to prevent contacts at:
- in-running nip points,
- power transmission,
- feed roll parts, and
- the unused portion of the abrasion belt on the operator's side of the machine.
What should you avoid when using sanders?
- Do not sand small or thin hand-held work pieces.
- Do not wear loose clothing or jewelry while using revolving power tools. Tie back long hair or wear appropriate hair protection. These measures will prevent hair, clothing, or jewellery (like dangling neck chains) from being caught and pulled by sander belts and pulleys that are in motion.
- Do not operate sanders without the exhaust system operating.
- Do not operate sanders unless adequately guarded.
- Do not operate sanders unless the work rest is properly adjusted.
Document last updated on April 2, 2012
Copyright ©1997-2013 Canadian Centre for Occupational Health & Safety